![]() ![]() I ve been tap-tap-tapping table saw fences professionally for close to 4 decades now. ![]() I have a Shop Fox, and the fence is accurate enough… Had a Ridgid Contractor saw before that, and it was accurate enough. They re also almost all made in China (after 2020, a No-go for me). That s probably close enough, but it would bug me (maybe not anyone else) enough to sand/shave. So, unless bolted-down existing gear or piles of crap forces a non-optimal placement for your RT/TS-with-Incra-LS, another non-issue.ĭROs repeatability is only repeatable to within the tolerance of the DRO (+/-). Going around the long way to make this an issue seems a bit much to me, and I have a small shop (AKA my garage). The only issue will be when you are using it…if you want to go the non-working-end-of-the-table route (CounterClockWise), you ll have to slide it closed …or just go CW. I ve seen the Incra TS-LS stored, and store my router table Incra router table LS-25 setup, with the Incra fence not fully extended. I can get repeatability to 0.005" without the bump-bump… I also have a Wixely DRO mounted on the fence. I have a Vega Pro 40 mounted on a Craftsman contractor table saw. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |